Skip to main content

MOSFET

IRF3711Z


Type Designator: IRF3711Z
Type of Transistor: MOSFET
Type of Control Channel: N -Channel
Maximum Power Dissipation (Pd): 79 W
Maximum Drain-Source Voltage |Vds|: 20 V
Maximum Gate-Source Voltage |Vgs|: 20 V
Maximum Gate-Threshold Voltage |Vgs(th)|: 2.45 V
Maximum Drain Current |Id|: 92 A
Maximum Junction Temperature (Tj): 175 °C
Maximum Drain-Source On-State Resistance (Rds): 0.006 Ohm
Package: TO220AB

Search Reference: https://alltransistors.com/mosfet/crsearch.php

Comments

Post a Comment

Popular posts from this blog

Voltage booster from 1.5 to 12 volt

Lighting up 12 volt LED strip with 1.5 volt battery This is a simple voltage booster circuit. It can increase the voltage of a power source by changing the constant low voltage signal into a series of rapid pulses at a higher voltage. You most commonly see this kind of circuit used to power LEDs with a “dead” battery, but there are many more potential applications for a circuit like this. Any NPN transistor like BC547 1K Resistor 12 Volt LED strip Enamel coated Copper wire preferable SW32 Ferite Ring You can source Ferite ring from dead CFL Bulb Please check out below demo Background: How Does a it Work? This circuit is a self-oscillating voltage booster. It takes a steady low voltage signal and converts it into a series of high frequency pulses at a higher voltage.  Here is how a basic it works, step by step: 1. Initially the transistor is off. 2. A small amount of electricity goes through the resistor and the first coil to the
Post a Comment
Read more

Coupling

AC Coupling : AC coupling consists of using a capacitor to filter out the DC signal component from a signal with both AC and DC components. The capacitor must be in series with the signal. AC coupling is useful because the DC component of a signal acts as a voltage offset, and removing it from the signal can increase the resolution of signal measurements. AC coupling is also known as capacitive coupling. DC Coupling:  DC coupling allows both AC and DC signals to pass through a connection. When using DC coupling, no additional capacitor is added to filter the signal. The DC-coupled configuration is usually best if the signal source has only small amounts of offset voltage, less than ±100 mV, or if the DC content of the acquired signal is important. Download Excel Simulator
Post a Comment
Read more